Need a 90-degree bracket, a U-channel cover, or a bent flange on a piece of plate? Our Marietta location runs a press brake, which means flat stock can leave the counter already bent to the angle your project calls for. For a lot of small shops and contractors, that's one less setup, one less tool to buy, and one less trip back to fix a bend that didn't land right.
Bending works on sheet, plate, and flat bar in steel, aluminum, and stainless, within the thickness and length limits for each material. Bring a sketch with your dimensions, the angle you need, and whether measurements are inside or outside the bend. Our counter team will tell you whether the bend is doable and how material choice affects it, since aluminum and stainless don't behave exactly like mild steel under the brake.
Pair it with our other in-house services, cutting, shearing, drilling, and hole punching, and parts can come out ready to weld or bolt together. There's no minimum order, so a single bracket gets the same attention as a full run of parts.
What's a part you're still bending by hand, or with a vise and a hammer, that you'd rather have done on a brake?
#MetalFabrication #MariettaGA
Authentic photo or short video of the press brake at the Marietta location bending a piece of flat bar or plate, ideally with the finished bracket or channel beside it. Real photos strongly preferred over stock. No Google Drive image folder is set up for this client yet, so request a real photo from the Marietta location.
Canva text suggestion: "Flat Stock In, Bent Part Out" or "Cut, Sheared, Drilled, and Bent in Marietta"